ISolidFireElementRemoveDrives Method (Int64)

You can use RemoveDrives to proactively remove drives that are part of the cluster. You might want to use this method when reducing cluster capacity or preparing to replace drives nearing the end of their service life. Any data on the drives is removed and migrated to other drives in the cluster before the drive is removed from the cluster. This is an asynchronous method. Depending on the total capacity of the drives being removed, it might take several minutes to migrate all of the data. Use the GetAsyncResult method to check the status of the remove operation. When removing multiple drives, use a single RemoveDrives method call rather than multiple individual methods with a single drive each. This reduces the amount of data balancing that must occur to even stabilize the storage load on the cluster. You can also remove drives with a "failed" status using RemoveDrives. When you remove a drive with a "failed" status it is not returned to an "available" or active status. The drive is unavailable for use in the cluster. Use the ListDrives method to obtain the driveIDs for the drives you want to remove.

AsyncHandleResult RemoveDrives(
	long[] Drives
)